beadboard ceiling planks – Use beadboard panels as a ceiling, you’ll be able to create a pretty and comfortable environment in a room. And better of all, beadboard panels are usually not solely low-cost but in addition simple to put in. Decide what number of boards of beadboard you want, with further boards for scraps. Beadboard is often three ½ inches lengthy, eight meters lengthy and 5/16 inches thick. Allow them to dry fully earlier than attaching them to the ceiling.
You will note the beams, if in case you have eliminated the previous drywall from the beadboard ceiling planks. If you don’t plan to take away the drywall, discover the ceiling joists utilizing a stud search. Run caulk strains in any respect joist areas. Use 4d ending nails, hammer first board in place, beginning with the grooved edge in opposition to the wall. Drill pilot holes by means of the plank face close to the wall and nail edge to the beams.
Maintain a block of wooden in opposition to the opposite plank’s tongue and faucet it with a hammer, which falls within the groove and tongue collectively tightly. Nail the second ingredient somewhat than simply by means of the tongue utilizing a nailset. Proceed this methodology till you attain the final plank. Usually, the final plank be too huge, use a desk or round noticed to chop it to the suitable width. Set up the final plank’s not the tongue of the earlier plank, drill holes and nail final plank by means of his face, as you probably did with the primary plank. Lastly, add your molding to trim the sting of the beadboard ceiling planks.